Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY

REAR NO. 2 SEAT ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR NO. 2 SEAT ASSEMBLY LH
  1. Place the rear No. 2 seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    If installing the seat on the RH side with the LH side installed, install it with the rear seat leg cover LH raised.

  1. Temporarily install the 4 bolts.

  1. Tighten the 4 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    B240281E01
  1. Attach the 6 claws and 2 guides to close the 2 covers.
    Text in Illustration 
    *1
    Guide



2. INSTALL NO. 1 DECK BOARD BRACKET LH
  1. Install the bracket with the 2 bolts.



3. INSTALL DECK BOARD BRACKET REINFORCEMENT
  1. Attach the 2 hooks to install the reinforcement.

  1. Install the 2 bolts.



4. INSTALL REAR NO. 3 FLOOR BOARD


    B240282E01
  1. Attach the 2 guides and 4 claws.
    Text in Illustration 
    *1
    Guide

  1. Attach the clip to install the board.



5. INSTALL REAR NO. 4 FLOOR BOARD


    B240283E01
  1. Attach the 2 guides and 4 claws.
    Text in Illustration 
    *1
    Guide

  1. Attach the clip to install the board.



6. INSTALL REAR FLOOR MAT SUPPORT PLATE
  1. Attach the 5 clips and 2 guides.

  1. Attach the 4 claws to install the plate.

  1. Install the 3 bolts.



7. INSTALL DECK BOARD ASSEMBLY
  1. Attach the 4 clips to install the board.

  1. Install the 2 bolts.



    B240101
  1. Attach the 2 claws to close the cover.

    HINT:
    Use the same procedure to close the cover on the other side.