Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY

REAR NO. 2 SEAT ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE DECK BOARD ASSEMBLY
  1. Pull the 2 rear seat lock release straps and fold down the 2 headrests.

  1. Operate the 2 rear seat lock release levers and fold down the 2 seatbacks.



    B237359E01
  1. Using a screwdriver, detach the 2 claws and open the cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure to open the cover on the other side.



    B237360
  1. Remove the 2 bolts.

  1. Detach the 4 clips and remove the deck board.



2. REMOVE REAR FLOOR MAT SUPPORT PLATE


  1. Remove the 3 bolts.


    B237363E01


    Text in Illustration 
    *1
    Guide
    -
    -

  1. Detach the 4 claws and 2 guides.

  1. Detach the 5 clips and remove the support plate.



3. REMOVE REAR NO. 4 FLOOR BOARD


    B237361E01
  1. Using a moulding remover, detach the clip and 4 claws.
    Text in Illustration 
    *1
    Guide

  1. Detach the 2 guides and remove the floor board.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B237362E01
  1. Using a moulding remover, detach the clip and 4 claws.
    Text in Illustration 
    *1
    Guide

  1. Detach the 2 guides and remove the floor board.



5. REMOVE DECK BOARD BRACKET REINFORCEMENT


    B237364E01
  1. Remove the 2 bolts.
    Text in Illustration 
    *1
    Hook

  1. Detach the 2 hooks and remove the reinforcement.



6. REMOVE NO. 1 DECK BOARD BRACKET LH


    B237365
  1. Remove the 2 bolts and bracket.



7. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
  1. Operate the seat cushion lock release lever and raise the seatback.

  1. Pull out the seat cushion.



    B237367
  1. Remove the 2 bolts.



    B237357E01
  1. Using a screwdriver, detach the 2 guides and 6 claws and open the 2 covers.
    Text in Illustration 
    *1
    Guide
    *2
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    B237358
  1. Remove the 2 bolts.



    B236507
  1. Remove the rear No. 2 seat assembly from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    If removing the seat on the RH side with the LH side installed, remove it with the No. 3 rear seat leg cover LH raised as shown in the illustration.