Home › Vehicle Interior › POWER OUTLETS (INT) › VOLTAGE INVERTER

VOLTAGE INVERTER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VOLTAGE INVERTER ASSEMBLY

HINT:
Remove interior parts so that the voltage inverter can be seen.



    B237242E06
  1. Disconnect the voltage inverter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:

    Tester Connection
    Switch Condition
    Specified Condition
    N20-1 (GND) - N20-2 (+B)
    Engine switch on (IG)
    11 to 14 V
    N20-1 (GND) - Body ground
    Always
    Below 1 V

    If the result is not as specified, repair or replace the harness or connector.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Voltage Inverter Assembly)



    B237241E05
  1. Reconnect the voltage inverter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:

    Tester Connection
    Switch Condition
    Specified Condition
    N19-5 (AC1) - N19-11 (AC2)
    Engine switch on (IG), main switch on
    AC 120 V

    If the result is not as specified, replace the voltage inverter assembly.
    Text in Illustration 
    *a
    Component with harness connected
    (Voltage Inverter Assembly)