Home › Vehicle Interior › POWER OUTLETS (INT) › INVERTER MAIN SWITCH

INVERTER MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL MAIN SWITCH ASSEMBLY
  1. Attach the 2 claws to install the main switch.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Connect each connector and hood lock control cable assembly.

  1. Attach the 13 clips and 2 guides to install the lower instrument panel finish panel sub-assembly.

  1. Install the 2 bolts <C>.

  1. Attach the 2 claws to close the cover.



3. INSTALL COWL SIDE TRIM BOARD LH
  1. Attach the clip and claw to install the cowl side trim board LH.

  1. Install the clip.



4. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly LH.



5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.