Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    E127507E34
  1. Apply battery voltage to the connector and check the light illumination condition.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → Terminal 1(B)
    Battery negative (-) → Terminal 2(E)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Side Turn Signal Light Assembly LH)
    If the result is not as specified, replace the side turn signal light assembly LH.