Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here


NOTICE:
Do not disconnect the hoses indicated in the illustration.

A223122


1. INSTALL FUEL MAIN VALVE ASSEMBLY


    A223172E01
  1. Apply a light coat of gasoline to 2 new O-rings and install the O-rings to the fuel main valve.
    Text in Illustration 
    *1
    New O-Ring

  1. Install the fuel main valve to the fuel filter case.

    NOTICE:
    Make sure the O-rings are not cut or pinched during installation.



2. INSTALL FUEL PUMP
  1. Connect the fuel pump wire harness connector to the fuel pump.



    A223260E01
  1. Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump.
    Text in Illustration 
    *1
    New O-Ring
    *2
    Fuel Pump Spacer



    A223259E01
  1. Attach the 5 claws to the claw holes to install the fuel pump to the fuel filter case.
    Text in Illustration 
    *1
    Fuel Filter Case



3. INSTALL NO. 1 FUEL SUB-TANK


    A223171
  1. Attach the 3 claws to the claw holes to install the No. 1 fuel sub-tank.



    A223170
  1. Attach the 3 claws to the claw holes.



  1. Install the tube part to the No. 1 fuel sub-tank.



      A223268E01
    1. Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the No. 1 fuel sub-tank.

  1. Connect the jet pump to the No. 1 fuel sub-tank.
    Text in Illustration 
    *1
    Jet Pump

  1. Connect the fuel pump connector.



4. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A223133E01
  1. Set the fuel sender gauge on the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.