Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > DISASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE SEAT ADJUSTER COVER CAP


B239170
  1. Remove the 2 seat adjuster cover caps.



2. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)


    B357316
  1. Detach the 2 hooks and disconnect the 2 rubber bands.



    B360690E01
  1. Apply protective tape to the locations shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B360691E01
  1. Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Point (A)

  1. Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 seatback board clips from the front seatback board sub-assembly LH.

    HINT:
    Tape the screwdriver tip before use.



    B360692
  1. Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.



3. REMOVE FRONT SEATBACK BOARD CLIP (w/ Climate Control Seat System)


    B360693
  1. Remove the 2 front seatback board clips from the separate type front seatback spring assembly.



4. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


B239530
  1. Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.



5. REMOVE RECLINING POWER SEAT SWITCH KNOB


B239532
  1. Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.



6. REMOVE FRONT SEAT CUSHION SHIELD LH


  1. Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.


    B239534

  1. Using a moulding remover, detach the 3 claws and guide.

  1. Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.

  1. Detach the clip of the front seat No. 1 inner cushion shield LH.

  1. Disconnect the lifter motor connector.



    B239536
  1. Detach the 3 claws and open the wire harness cover.

  1. Detach the 3 wire harness clamps and disconnect the seat wire connector.



7. REMOVE FRONT POWER SEAT SWITCH LH


B239537
  1. Remove the 3 screws.

  1. Disconnect the power seat switch connector and remove the switch.



8. REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)


B239538
  1. Using a screwdriver, detach the 2 claws.

  1. Disconnect the lumbar switch connector and remove the lumbar switch.



9. REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH


    B239540
  1. Detach the 2 claws and remove the front seat No. 1 inner cushion shield LH.



10. REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)


    B239167
  1. Using a moulding remover, detach the 3 claws and remove the front seat inner cushion shield LH.



11. REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)


B239169
  1. Using a moulding remover, detach the 4 claws and remove the front seat inner cushion shield RH.



12. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. for Driver Side:
    Disconnect the connector and detach the 4 clamps.

  1. for Passenger Side:
    Disconnect the connector and detach the clamp.



    B241691
  1. Remove the nut and front seat inner belt.



13. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY


  1. w/o Climate Control Seat System:



      B239173
    1. Remove the rubber band from the separate type front seat cushion spring assembly.



    2. B241809
    3. Detach the clamp and disconnect the No. 2 seat wire.



    4. B241810
    5. w/ Seat Heater System:
      Disconnect the seat heater connector and detach the seat heater wire harness clamp.



    6. B247920
    7. Detach the 2 hooks.



    8. B239174E01
    9. Detach the claw and disconnect the airbag connector.

    10. Detach the 3 airbag wire harness clamps.

    11. Detach the fastening tape to disconnect the airbag wire harness.
      Text in Illustration 
      *1
      Fastening Tape



    12. B239178
    13. Remove the 4 bolts and separate type front seatback assembly.



  1. w/ Climate Control Seat System:



      B247919
    1. Detach the clamp and disconnect the No. 2 seat wire.

    2. Disconnect the seat heater connector and detach the seat heater wire harness clamp.



    3. B247920
    4. Detach the 2 hooks.



    5. B357320E01
    6. Detach the claw and disconnect the airbag connector.

    7. Detach the 3 airbag wire harness clamps.

    8. Detach the fastening tape to disconnect the airbag wire harness.
      Text in Illustration 
      *1
      Fastening Tape



    9. B239178
    10. Remove the 4 bolts and separate type front seatback assembly.



14. REMOVE FRONT SEAT LEG COVER LH


B239171
  1. Detach the 2 claws.

  1. Move the front seat leg cover LH in the direction of the arrow to remove it.



15. REMOVE SEAT CUSHION COVER WITH PAD


    B357321
  1. w/ Seat Heater System:
    Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.



  1. Detach each hook to remove the seat cushion cover with pad.


    B357322



16. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    B239182
  1. Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.



17. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)


    B247952
  1. Disconnect the wire harness from the separate type front seat cushion cover.



    B239184E01
  1. Cut off the 22 tack pins and remove the front seat cushion heater from the front seat cushion cover.
    Text in Illustration 
    *1
    Tack Pin



18. REMOVE RECLINING ADJUSTER INSIDE COVER LH


    B357535
  1. Detach the claw and guide, and then remove the reclining adjuster inside cover LH.



19. REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)


    B239543
  1. Remove the screw.

  1. Detach the hook and clip, and then remove the front seat lower cushion shield LH.



20. REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)


    B247926
  1. Remove the screw.

  1. Detach the hook and clip, and then remove the front seat lower cushion shield RH.



21. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH


    B239188
  1. Remove the screw.

  1. Move the front seat cushion edge protector LH in the direction of the arrow to detach the hook and remove the front seat cushion edge protector LH.



22. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH

HINT:
Use the same procedure described for the LH side.



23. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)


B239190
  1. Disconnect the connector.

  1. Detach the 2 clamps and remove the seat heater control.



24. REMOVE SEAT CUSHION CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)


    B357323
  1. Detach the 2 claws.



    B357324
  1. Detach the 3 claws to remove the seat cushion climate control duct LH.



25. REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)


    B357325
  1. Disconnect the connector.

  1. Detach the 4 guides and remove the seat cushion climate control blower assembly LH.



26. REMOVE SEAT CUSHION CLIMATE CONTROL BRACKET LH (w/ Climate Control Seat System)


    B357326
  1. Remove the 2 screws and seat cushion climate control bracket LH.



27. REMOVE OCCUPANT CLASSIFICATION ECU (for Front Passenger Side)


B239191
  1. Disconnect the 2 connectors.

  1. Detach the claw and remove the occupant classification ECU.



28. REMOVE FRONT SEAT WIRE LH
  1. Disconnect each connector and disengage each clamp to remove the front seat wire LH.



29. REMOVE RECLINING ADJUSTER INSIDE COVER LH


B239544
  1. Detach the guide and remove the reclining adjuster inside cover LH.



30. REMOVE RECLINING ADJUSTER INSIDE COVER RH

HINT:
Use the same procedure described for the LH side.



31. REMOVE SEATBACK COVER WITH PAD


  1. w/o Climate Control Seat System:



      B239192
    1. Remove the 3 hog rings.



    2. Open the 2 fasteners and separate type front seatback cover.


      B242232E01


      Text in Illustration 
      *A
      for Cloth Seat
      *B
      for Leather Seat



    3. B247934
    4. Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the seatback spring.



    5. B239198
    6. Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.

    7. Remove the seatback cover with pad from the separate type front seatback spring assembly.



  1. w/ Climate Control Seat System:



      B360694
    1. Detach the 7 hooks.



    2. B247933
    3. Remove the 5 hog rings.



    4. B247934
    5. Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the seatback spring.



    6. B239198
    7. Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.

    8. Remove the seatback cover with pad from the separate type front seatback spring assembly.



32. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B247935
  1. Disconnect the seatback cover bracket from the separate type front seatback pad.



    B239205
  1. Remove the 13 hog rings and separate type front seatback cover.



33. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)


    B247953E01
  1. Cut off the 10 tack pins which fasten the front seatback heater assembly LH to the separate type front seatback cover, and then remove the front seatback heater assembly LH from the separate type front seatback cover.
    Text in Illustration 
    *1
    Tack Pin



34. REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)


    B357327
  1. Disconnect the connector.

  1. Remove the 4 screws and seatback climate control blower LH.



35. REMOVE SEATBACK CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)


    B357328
  1. Detach the 2 claws to remove the seatback climate control duct LH.



36. REMOVE NO. 2 SEAT WIRE
  1. Disconnect each connector and disengage each clamp to remove the No. 2 seat wire.



37. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY


    B274337
  1. Detach the 2 clamps to disconnect the front seat side airbag wire harness.



    B274336
  1. Using an E10 "TORX" socket wrench, remove the 2 nuts and front seat side airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.