Home › Vehicle Interior › SEAT › LUMBAR SWITCH

LUMBAR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT LUMBAR SWITCH ASSEMBLY


B239575E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (H) - 5 (B)
    Hold
    Below 1 Ω
    1 (R) - 2 (E2)
    2 (E2) - 3 (H)
    Off
    2 (E2) - 1 (R)
    2 (E2) - 3 (H)
    Release
    1 (R) - 5 (B)

    If the result is not as specified, replace the lumbar switch.
    Text in Illustration 
    *1
    Hold Switch
    *2
    Release Switch
    *a
    Component without harness connected
    (Lumbar Switch)