Home › Vehicle Interior › SEAT › LUMBAR SWITCH

LUMBAR SWITCH > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).



2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


B239530
  1. Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB


B239532
  1. Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.



4. REMOVE FRONT SEAT CUSHION SHIELD LH


  1. Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.


    B239534

  1. Using a moulding remover, detach the 3 claws and guide.

  1. Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.

  1. Detach the clip of the front seat No. 1 inner cushion shield LH.

  1. Disconnect the lifter motor connector.



    B239536
  1. Detach the 3 claws and open the wire harness cover.

  1. Detach the 3 wire harness clamps and disconnect the seat wire connector.



5. REMOVE FRONT POWER SEAT SWITCH LH


B239537
  1. Remove the 3 screws.

  1. Disconnect the power seat switch connector and remove the switch.



6. REMOVE LUMBAR SWITCH ASSEMBLY


B239538
  1. Using a screwdriver, detach the 2 claws.

  1. Disconnect the lumbar switch connector and remove the lumbar switch.