Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER

FRONT SEATBACK HEATER > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)


    B357316
  1. Detach the 2 hooks and disconnect the 2 rubber bands.



    B360690E01
  1. Apply protective tape to the locations shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B360691E01
  1. Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Point (A)

  1. Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 seatback board clips from the front seatback board sub-assembly LH.

    HINT:
    Tape the screwdriver tip before use.



    B360692
  1. Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.



3. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


  1. w/o Climate Control Seat System:



      B239173
    1. Remove the rubber band from the seat cushion spring.



    2. B241810
    3. Disconnect the seat heater connector and detach the seat heater wire harness clamp.



    4. B239192
    5. Remove the 3 hog rings.



    6. Open the 2 fasteners and then open the seatback cover.


      B242232E01


      Text in Illustration 
      *A
      for Cloth Seat
      *B
      for Leather Seat



    7. B247934
    8. Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the separate type front seatback spring assembly.



    9. B239198
    10. Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.



  1. w/ Climate Control Seat System:



      B248652
    1. Disconnect the seat heater connector and detach the seat heater wire harness clamp.



    2. B360694
    3. Detach the 7 hooks.



    4. B247933
    5. Remove the 5 hog rings.



    6. B247934
    7. Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the separate type front seatback spring assembly.



    8. B239198
    9. Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.

    10. Remove the seatback cover with pad from the seatback spring.



4. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B247935
  1. Disconnect the seatback cover bracket from the separate type front seatback pad.



    B239205
  1. Remove the 13 hog rings and separate type front seatback cover.



5. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH


    B247953E01
  1. Cut off the 10 tack pins which fasten the front seatback heater assembly LH to the separate type front seatback cover, and then remove the front seatback heater assembly LH from the separate type front seatback cover.
    Text in Illustration 
    *1
    Tack Pin