Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)

REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR SEAT HEADREST ASSEMBLY
  1. Remove the headrest.



2. REMOVE REAR SEAT TRACK INNER BRACKET COVER


B237608
  1. Using a moulding remover, detach the 2 claws and guide, and then remove the cover.



3. REMOVE REAR SEAT TRACK OUTER BRACKET COVER


B237606
  1. Using a moulding remover, detach the 2 claws.

  1. Move the cover in the direction of the arrow to detach the 2 guides, and then remove the cover.



4. REMOVE SEAT TRACK INNER BRACKET COVER LH


B237612
  1. Using a clip remover, detach the 6 clips and remove the cover.



5. REMOVE REAR SEAT TRACK COVER LH


B237610
  1. Using a clip remover, detach the 3 clips and remove the cover.



6. REMOVE REAR SEAT ASSEMBLY LH


B237788
  1. Disconnect the center inner seat belt from the seat.

  1. Remove the 5 bolts, nut and seat.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    Be sure to remove the seat with the seatback folded down.