Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)

REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH


B242874E01
  1. Install the inner belt and connect the center outer belt with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

    Text in Illustration 
    *a
    Protruding Part



2. INSTALL SEAT CUSHION COVER WITH PAD


    B237625
  1. Attach the hook.



    B237623
  1. Attach the hooks to install the seat cushion cover with pad.



3. INSTALL REAR SEATBACK LOCK STRIKER COVER LH
  1. Attach the 3 clips to install the cover.



4. INSTALL REAR SEAT CUSHION MOULDING LH


B237682
  1. Move the moulding in the direction of the arrow to attach the guide.

  1. Attach the 4 claws and clip to install the moulding.



5. INSTALL CENTER SEAT HINGE COVER RH


B237618
  1. Attach the 2 guides and install the cover with the clip.



6. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
  1. Install the handle with the 3 screws.



7. INSTALL REAR SEAT UPPER RECLINING COVER LH


B237786
  1. Attach the 3 claws to install the cover.



8. INSTALL REAR SEAT ASSEMBLY LH
  1. Install the rear seat assembly LH (Click here).