Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)

REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. INSTALL REAR SEAT ASSEMBLY RH


B237614E01
  1. Place the seat in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    Be sure to install the seat with the seatback folded down.

  1. Connect the center inner belt to the seat.

  1. Temporarily install the seat with the 5 bolts and nut.

  1. Tighten the bolts and nut in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. INSTALL REAR SEAT TRACK COVER RH
  1. Attach the 5 clips and claw to install the cover.



3. INSTALL SEAT TRACK INNER BRACKET COVER RH
  1. Attach the 8 clips to install the cover.



4. INSTALL REAR SEAT TRACK OUTER BRACKET COVER


B237704
  1. Move the cover in the direction of the arrow to attach the 2 guides.

  1. Attach the 2 claws to install the cover.



5. INSTALL REAR SEAT TRACK INNER BRACKET COVER


B237706
  1. Attach the 2 claws and guide to install the cover.



6. INSTALL REAR SEAT HEADREST ASSEMBLY
  1. Install the headrest.