Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)

REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR SEAT HEADREST ASSEMBLY
  1. Remove the headrest.



2. REMOVE REAR SEAT TRACK INNER BRACKET COVER


B237705
  1. Using a moulding remover, detach the 2 claws and guide, and then remove the cover.



3. REMOVE REAR SEAT TRACK OUTER BRACKET COVER


B237703
  1. Using a moulding remover, detach the 2 claws.

  1. Move the cover in the direction of the arrow to detach the 2 guides and remove the cover.



4. REMOVE SEAT TRACK INNER BRACKET COVER RH


B237797
  1. Using a clip remover, detach the 8 clips and remove the cover.



5. REMOVE REAR SEAT TRACK COVER RH


B237798
  1. Using a clip remover, detach the 5 clips and claw, and then remove the cover.



6. REMOVE REAR SEAT ASSEMBLY RH


B237789
  1. Disconnect the center inner seat belt from the seat.

  1. Remove the 5 bolts and nut.

  1. Remove the rear seat.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    Be sure to remove the seat with the seatback folded down.