Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING

ROOF HEADLINING > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)


B240032
  1. Remove the No. 1 roof silencer pad.



2. REMOVE NO. 2 ROOF SILENCER PAD


B240034
  1. w/o Sliding Roof:
    Remove the 2 No. 2 roof silencer pads.



    B240042
  1. w/ Sliding Roof:
    Remove the No. 2 roof silencer pad.



3. REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)


B240036
  1. Remove the No. 3 roof silencer pad.



4. REMOVE NO. 4 ROOF SILENCER PAD


B240038
  1. w/o Sliding Roof:
    Remove the No. 4 roof silencer pad.



    B240040
  1. w/ Sliding Roof:
    Remove the No. 4 roof silencer pad.



5. REMOVE VANITY LIGHT ASSEMBLY


B175184E02

HINT:
Use the same procedure for the other vanity light.

  1. Detach the 2 claws labeled A and separate the bulb holder from the vanity light as shown in the illustration.

  1. Detach the claw labeled B and remove the vanity light.
    Text in Illustration 
    *1
    Claw A
    *2
    Claw B
    *3
    Bulb Holder



6. REMOVE NO. 1 ROOF WIRE
  1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.



  1. Detach each clamp and remove the tape and No. 1 roof wire.


    B240078E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *C
    w/ EC Mirror
    -
    -
    *1
    Visor Connector
    *2
    Marking Tape



7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. w/o Sliding Roof:
    Remove the No. 2 antenna cord sub-assembly .

  1. w/ Sliding Roof:
    Remove the No. 2 antenna cord sub-assembly .