Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear)

ULTRASONIC SENSOR (for Rear) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER


    E198661E01
  1. Align the keyhole and protrusion as shown in the illustration.
    Text in Illustration 
    *1
    Keyhole

  1. Attach the 4 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper cover.

    NOTICE:
    Do not damage the bumper cover with the protrusion when installing the No. 1 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



2. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER


    E198663E01
  1. Align the keyhole and protrusion as shown in the illustration.
    Text in Illustration 
    *1
    Keyhole

  1. Attach the 3 claws to install the No. 2 ultrasonic sensor retainer to the rear bumper cover.

    NOTICE:
    Do not damage the bumper cover with the protrusion when installing the No. 2 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



3. INSTALL ULTRASONIC SENSOR CLIP
  1. Attach the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.

    HINT:
    Use the same procedure as for the other side.



4. INSTALL NO. 1 ULTRASONIC SENSOR
  1. Attach the 2 claws to install the No. 1 ultrasonic sensor to the ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



5. INSTALL NO. 3 FLOOR WIRE
  1. Clean the rear bumper surface.

    1. Using a heat light, heat the rear bumper surface.

    2. Remove the double-sided tape from the rear bumper surface.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Attach the 4 clamps to connect the 4 connectors.



  1. Install the No. 3 floor wire with the new 3 pieces of tape as shown in the illustration.

    HINT:
    1. With the wire harness contacting the rear bumper cover, wrap tape around as much of the wire harness as possible.
    2. Do not reuse the tape.
    3. Be sure to install the wire harness so that it is centered between the guidelines labeled B and attach the tape so that its edges are aligned with the guidelines labeled A.



    B356811E01


    Text in Illustration 
    *1
    Guideline A
    *2
    Guideline B



6. INSTALL REAR BUMPER COVER
  1. Connect the connector.

  1. Attach the 18 claws to install the rear bumper cover.

  1. Install the 8 bolts and 4 screws.



7. INSTALL REAR QUARTER PANEL MUDGUARD LH
  1. Install the rear quarter panel mudguard LH with the 4 screws and 4 clips.



8. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.



9. INSTALL JACK BOX HOLE COVER
  1. Attach the 2 guides and 2 claws to install the jack box hole cover.