Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front)

ULTRASONIC SENSOR (for Front) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER


    E198663E01
  1. Align the keyhole and protrusion as shown in the illustration.
    Text in Illustration 
    *1
    Keyhole

  1. Attach the 3 claws to install the No. 2 ultrasonic sensor retainer to the front bumper cover.

    NOTICE:
    Do not damage the front bumper cover with the protrusion when installing the No. 2 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



2. INSTALL ULTRASONIC SENSOR CLIP
  1. Attach the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.



3. INSTALL NO. 1 ULTRASONIC SENSOR
  1. Attach the 2 claws to install the No. 1 ultrasonic sensor to the No. 2 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



4. INSTALL NO. 2 ENGINE ROOM WIRE
  1. Attach the 9 clamps.

  1. Connect each connector and install the No. 2 engine room wire.



5. INSTALL FRONT BUMPER COVER
  1. Connect the 3 connectors.

  1. Attach the 14 claws to install the front bumper cover with radiator grille.

  1. Install the 3 bolts, 10 screws and 6 clips.



6. INSTALL UPPER RADIATOR SUPPORT SEAL
  1. Install the upper radiator support seal with the 13 clips.