Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear)

ULTRASONIC SENSOR (for Rear) > REMOVAL

for Preparation Click here



1. REMOVE JACK BOX HOLE COVER


    B239891E01
  1. Put protective around the jack box hole cover.

  1. Using a moulding remover, Detach the 2 claws and 2 guides and remove the jack box hole cover.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover



2. REMOVE REAR QUARTER PANEL MUDGUARD LH


B239353
  1. Remove the 4 clips, 4 screws and rear quarter panel mudguard LH.



3. REMOVE REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE REAR BUMPER COVER


  1. Remove the 2 bolts and 2 screws.


    B239890

  1. Put protective tape around the rear bumper cover.

  1. Remove the 2 screws and 6 bolts.



  1. Detach the 18 claws to remove the rear bumper cover.


    B239892E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -

  1. Disconnect the connector.



5. REMOVE NO. 3 FLOOR WIRE
  1. Disconnect the 4 connectors and remove the 3 pieces of tape.



  1. Detach the 4 clamps to remove the No. 3 floor wire.


    B356810



6. REMOVE NO. 1 ULTRASONIC SENSOR


    E201175
  1. Detach the 2 claws to remove the No. 1 ultrasonic sensor from the ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



7. REMOVE ULTRASONIC SENSOR CLIP


    B352864E01
  1. Using a screwdriver, detach the claw to remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure as for the other side.



8. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    E203373
  1. Detach the 3 claws to remove the No. 2 ultrasonic sensor retainer from the rear bumper cover.

    HINT:
    Use the same procedure as for the other side.



9. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E203372
  1. Detach the 4 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.

    HINT:
    Use the same procedure as for the other side.