Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front)

ULTRASONIC SENSOR (for Front) > REMOVAL

for Preparation Click here



1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.



2. REMOVE FRONT BUMPER COVER
  1. Put protective tape around the front bumper cover.

  1. Remove the 3 bolts, 10 screws and 6 clips.



  1. Detach the 14 claws to remove the front bumper cover with radiator grille.


    B353221E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -

  1. Disconnect 3 connectors.



3. REMOVE NO. 2 ENGINE ROOM WIRE
  1. Disconnect each connector.



  1. Detach the 9 clamps to remove the No. 2 engine room wire.


    B353487



4. REMOVE NO. 1 ULTRASONIC SENSOR


    E201175
  1. Detach the 2 claws to remove the No. 1 ultrasonic sensor from the No. 2 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



5. REMOVE ULTRASONIC SENSOR CLIP


    B352864E01
  1. Using a screwdriver, detach the claw to remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    E203373
  1. Detach the 3 claws to remove the No. 2 ultrasonic sensor retainer from the front bumper cover.

    HINT:
    Use the same procedure as for the other side.