Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (w/ Intuitive Parking Assist System)

FRONT BUMPER (w/ Intuitive Parking Assist System) > REASSEMBLY

for Preparation Click here



1. INSTALL FOG LIGHT ASSEMBLY LH
  1. Attach the 2 guides.

  1. Install the fog light assembly LH with the 2 screws.



2. INSTALL FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



3. INSTALL FRONT BUMPER MOULDING SUB-ASSEMBLY
  1. Attach the 4 claws and 12 guides to install the front bumper moulding sub-assembly.

  1. Install the 15 outside moulding retainers and 4 screws.



4. INSTALL FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH
  1. Attach the 2 claws and guide to install the front bumper side moulding sub-assembly LH.

  1. Install the 2 screws and 3 outside moulding retainers.



5. INSTALL FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



6. INSTALL NO. 2 RADIATOR GRILLE MOULDING
  1. Attach the 4 claws to install the No. 2 radiator grille moulding.

  1. Install the 2 outside moulding retainers and 4 screws.



7. INSTALL FRONT BUMPER LOWER SIDE SUPPORT LH
  1. Attach the 5 claws.

  1. Install the front bumper lower side support LH with the 2 clips.



8. INSTALL FRONT BUMPER LOWER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.



9. INSTALL FRONT BUMPER SIDE MOULDING LH
  1. Attach the claw to install the front bumper side moulding LH.

  1. Install the 2 outside moulding retainers.



10. INSTALL FRONT BUMPER SIDE MOULDING RH

HINT:
Use the same procedure as for the LH side.



11. INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
  1. Install the front bumper extension mounting bracket with the 2 screws.



12. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER


    E198663E01
  1. Align the keyhole and protrusion as shown in the illustration.
    Text in Illustration 
    *1
    Keyhole

  1. Attach the 3 claws to install the No. 2 ultrasonic sensor retainer to the front bumper cover.

    NOTICE:
    Do not damage the front bumper cover with the protrusion when installing the No. 2 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



13. INSTALL ULTRASONIC SENSOR CLIP
  1. Attach the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.



14. INSTALL NO. 1 ULTRASONIC SENSOR
  1. Attach the 2 claws to install the No. 1 ultrasonic sensor to the No. 2 ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



15. INSTALL NO. 2 ENGINE ROOM WIRE
  1. Attach the 9 clamps.

  1. Connect each connector and install the No. 2 engine room wire.



16. INSTALL RADIATOR GRILLE
  1. Attach the 10 claws and 2 guides to install the radiator grille.