Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (w/ Intuitive Parking Assist System)

REAR BUMPER (w/ Intuitive Parking Assist System) > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 3 FLOOR WIRE
  1. Disconnect the 4 connectors and remove the 3 pieces of tape.



  1. Detach the 4 clamps to remove the No. 3 floor wire.


    B356810



2. REMOVE REAR BUMPER SIDE BRACKET LH


    B239957
  1. Remove the clip and 2 screws.

  1. Detach the guide to remove the rear bumper side bracket LH.



3. REMOVE REAR BUMPER SIDE BRACKET RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE REAR BUMPER PLATE LH


    B239958
  1. Remove the 2 outside moulding retainers.

  1. Detach the claw to remove the rear bumper plate LH.



5. REMOVE REAR BUMPER PLATE RH


    B239959
  1. Remove the outside moulding retainer.

  1. Detach the claw to remove the rear bumper plate RH.



6. REMOVE NO. 1 REAR BUMPER PLATE


    B239960
  1. Remove the outside moulding retainer.

  1. Detach the claw to remove the No. 1 rear bumper plate.



7. REMOVE REAR BUMPER CENTER MOULDING


  1. Remove the 6 outside moulding retainers.


    B239961

  1. Detach the 4 claws to remove the rear bumper center moulding.



8. REMOVE NO. 1 ULTRASONIC SENSOR


    E201175
  1. Detach the 2 claws to remove the No. 1 ultrasonic sensor from the ultrasonic sensor retainer.

    HINT:
    Use the same procedure as for the other side.



9. REMOVE ULTRASONIC SENSOR CLIP


    B352864E01
  1. Using a screwdriver, detach the claw to remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure as for the other side.



10. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    E203373
  1. Detach the 3 claws to remove the No. 2 ultrasonic sensor retainer from the rear bumper cover.

    HINT:
    Use the same procedure as for the other side.



11. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E203372
  1. Detach the 4 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.

    HINT:
    Use the same procedure as for the other side.