Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER

REAR SPOILER > REASSEMBLY

for Preparation Click here


HINT:
When installing the rear spoiler protector, heat the rear spoiler surface using a heat light.

Standard:
Item
Temperature
Rear Spoiler
20 to 30°C (68 to 86°F)



1. INSTALL NO. 3 BACK DOOR WIRE
  1. Attach the clamp to install the No. 3 back door wire.



2. INSTALL CENTER STOP LIGHT ASSEMBLY
  1. Connect the connector.

  1. Install the stop light with the 2 screws.



3. INSTALL REAR SPOILER PROTECTOR LH


B240313

HINT:
Use the same procedure to install the rear spoiler protector on the other side.

  1. Clean the rear spoiler surface.

    1. Using a heat light, heat the rear spoiler surface.

    2. Remove the double-sided tape from the rear spoiler surface.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Install a new rear spoiler protector.

    1. Remove the peeling paper from the face of a new rear spoiler protector.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear spoiler protector as shown in the illustration.



4. INSTALL REAR NO. 2 SPOILER PROTECTOR


B240312

HINT:
Use the same procedure to install the rear No. 2 spoiler protector on the other side.

  1. Clean the rear spoiler surface.

    1. Using a heat light, heat the rear spoiler surface.

    2. Remove the double-sided tape from the rear spoiler surface.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Install a new rear No. 2 spoiler protector.

    1. Remove the peeling paper from the face of a new rear No. 2 spoiler protector.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear No. 2 spoiler protector as shown in the illustration.



5. INSTALL REAR NO. 1 SPOILER PROTECTOR


B240311

HINT:
Use the same procedure to install the No. 1 rear spoiler protector on the other side.

  1. Clean the rear spoiler surface.

    1. Using a heat light, heat the rear spoiler surface.

    2. Remove the double-sided tape from the rear spoiler surface.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Install a new rear No. 1 spoiler protector.

    1. Remove the peeling paper from the face of a new rear No. 1 spoiler protector.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear No. 1 spoiler protector as shown in the illustration.