Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD

AUTOMATIC RUNNING BOARD > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE STEP PLATE COVER LH


    B323164
  1. Remove the 2 screws and step plate cover LH.



2. REMOVE STEP PLATE COVER RH

HINT:
Use the same procedure as described for the step plate cover LH.



3. REMOVE SIDE AUTO STEP MOTOR ASSEMBLY


    B295792
  1. Disengage the 4 clamps.



    B295793
  1. Remove the bolt.

  1. Using a 6 mm hexagon wrench, remove the 3 hexagon bolts and side auto step motor assembly.



4. REMOVE FLOOR SIDE SILL STAY


  1. Remove the 6 bolts and floor side sill stay.


    B296716