Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF RACK

ROOF RACK > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL ROOF RAIL ASSEMBLY LH
  1. Clean the threads of the bolt with non-residue solvent (when reusing the bolt).

  1. Apply adhesive to the threads of the bolt (when reusing the bolt).

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

  1. Install the roof rail with the 4 bolts.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }



2. INSTALL FRONT ROOF RACK LEG COVER LH
  1. Attach the 4 claws to install the front roof rack leg cover.



3. INSTALL REAR ROOF RACK LEG COVER LH
  1. Attach the 4 claws to install the rear roof rack leg cover.