Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF RACK

ROOF RACK > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT ROOF RACK LEG LH
  1. Clean the threads of the bolt with non-residue solvent (when reusing the bolt).

  1. Apply adhesive to the threads of the bolt (when reusing the bolt).

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

  1. Using a T30 "TORX" socket wrench, install the front roof rack leg with the 2 bolts.



2. INSTALL REAR ROOF RACK LEG LH
  1. Clean the threads of the bolt with non-residue solvent (when reusing the bolt).

  1. Apply adhesive to the threads of the bolt (when reusing the bolt).

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

  1. Using a T30 "TORX" socket wrench, install the rear roof rack leg with the 2 bolts.



3. INSTALL NO. 1 ROOF CARRIER SUPPORT LH
  1. Attach the 2 claws to install the No. 1 roof carrier support.



4. INSTALL ROOF RACK PROTECTOR LH
  1. Attach the 2 claws to install the roof rack protector.



5. INSTALL FRONT ROOF RACK LEG CUSHION LH
  1. Attach the 4 claws to install the front roof rack leg cushion.



6. INSTALL REAR ROOF RACK LEG CUSHION LH
  1. Attach the 4 claws to install the rear roof rack leg cushion.