Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System)

ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL NO. 6 ROCKER PANEL REINFORCEMENT
  1. Install the No. 6 rocker panel reinforcement with the 6 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. INSTALL ROCKER PANEL MOULDING LH
  1. Attach the 15 clips to install the rocker panel moulding LH.

  1. Install the 4 screws.



3. INSTALL FRONT FENDER MUDGUARD LH
  1. Install the front fender mudguard LH with the screw and 2 clips.