Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL NO. 2 ROCKER PANEL MOULDING PROTECTOR (w/o Side Step)
  1. Install the No. 2 rocker panel moulding protector with the 2 screws.



2. INSTALL ROCKER PANEL MOULDING LH
  1. Attach the 7 clips to install the rocker panel moulding LH.

  1. Install the 3 screws.

  1. Attach the 7 retainers and clip.



3. INSTALL SIDE STEP ASSEMBLY LH (w/ Side Step)
(Click here)