Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System)

ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT FENDER MUDGUARD LH


    B295842
  1. Remove the 2 clips, screw and front fender mudguard LH.



2. REMOVE ROCKER PANEL MOULDING LH
  1. Put protective tape around the rocker panel moulding LH.

  1. Remove the 4 screws.



  1. Detach the 15 clips to remove the rocker panel moulding LH.


    B353494E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



3. REMOVE NO. 6 ROCKER PANEL REINFORCEMENT


  1. Remove the 6 bolts and No. 6 rocker panel reinforcement.


    B239361