Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE SIDE STEP ASSEMBLY LH (w/ Side Step)
(Click here)


2. REMOVE ROCKER PANEL MOULDING LH


  1. Remove the 7 retainers, clip and screw.


    B239355

  1. Put protective tape around the rocker panel moulding LH.

  1. Remove the 2 screws.



  1. Detach the 7 clips to remove the rocker panel moulding LH.


    B353493E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



3. REMOVE NO. 2 ROCKER PANEL MOULDING PROTECTOR (w/o Side Step)


B239357
  1. Remove the 2 screws and No. 2 rocker panel moulding protector.