4WD CONTROL SWITCH > REMOVAL |
| 1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Put protective tape around the upper console panel sub-assembly.
| *1 | Protective Tape |
Using a moulding remover, detach the 10 clips.

| *A | for VF2A | *B | for VF2BM, VF4BM |
| *C | for 2WD | - | - |
| *1 | Protective Tape | - | - |
Disconnect each connector and remove the upper console panel sub-assembly.
| 2. REMOVE FRONT UPPER CONSOLE PANEL GARNISH |
for VF2A:
![]() |
Detach the 6 claws to remove the front upper console panel garnish.
| *A | for VF2A |
for 2WD, for VF2BM, VF4BM:
Detach the 10 claws to remove the front upper console panel garnish.

| *A | for 2WD | *B | for VF2BM, VF4BM |
| 3. REMOVE TRANSFER POSITION SWITCH |
![]() |
Detach the 3 claws and remove the transfer position switch.