Home › Drivetrain ยท VF2BM TRANSFER / 4WD / AWD › 4WD CONTROL ECU

4WD CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL FOUR WHEEL DRIVE CONTROL ECU
  1. Install the four wheel drive control ECU with the bolt.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the 2 connectors.



2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector.

  1. Attach the 10 clips and guide to install the lower instrument panel sub-assembly.

  1. Install the 3 screws <B> and 2 bolts <C>.



3. INSTALL INSTRUMENT PANEL BOX DOOR COVER
  1. Attach the 2 claws and 2 guides to install the instrument panel box door cover.

    HINT:
    Use the same procedure for all the instrument panel box door covers.



4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240163
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 8 claws to install the instrument panel airbag.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



5. INSTALL LOWER INSTRUMENT COVER LH
  1. Attach the 4 claws to install the lower instrument cover LH.



6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.



7. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side.



8. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.