Home › Drivetrain ยท VF2BM TRANSFER / 4WD / AWD › 4WD CONTROL ECU

4WD CONTROL ECU > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Open the instrument cluster finish panel lid.

  1. Put protective tape around the No. 2 instrument cluster finish panel garnish.



  1. Grip the No. 2 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 2 instrument cluster finish panel garnish.


    B246534E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B239284
  1. Detach the 3 clips and 2 guides to remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE LOWER INSTRUMENT COVER LH


    B239283E01
  1. Put protective tape around the lower instrument cover LH.

  1. Using a screwdriver, detach the 4 claws to remove the lower instrument cover LH.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240162
  1. Remove the 3 bolts.

  1. Detach the 8 claws and remove the instrument panel airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. REMOVE INSTRUMENT PANEL BOX DOOR COVER


    B239281E01
  1. Using a screwdriver, detach the 2 claws and 2 guides to remove the instrument panel box door cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for all the instrument panel box door covers.



8. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B239282
  1. Remove the 3 screws <B> and 2 bolts <C>.

  1. Detach the 10 clips and guide.

  1. Disconnect each connector and remove the lower instrument panel sub-assembly.



9. REMOVE FOUR WHEEL DRIVE CONTROL ECU


C216636
  1. Disconnect the 2 connectors.

  1. Remove the bolt and four wheel drive control ECU.