Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › AIR PUMP

AIR PUMP > INSPECTION

for Preparation Click here



1. INSPECT AIR PUMP ASSEMBLY


  1. Check the heater resistance.



      A226958E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (APH+) - 3 (APHG)
      -20°C (-4°F)
      3.6 to 17.6 Ω
      -10°C (14°F)
      3.4 to 16.5 Ω
      0°C (32°F)
      3.1 to 15.4 Ω
      10°C (50°F)
      2.8 to 14.3 Ω
      20°C (68°F)
      2.7 to 13.2 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Air pump assembly)
      If the result is not as specified, replace the air pump assembly.