Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MOULDING

SIDE MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System)


    B353242
  1. Remove the 2clips, 3 screws and front fender mudguard LH.



2. REMOVE FRONT FENDER MUDGUARD LH (w/ Intuitive Parking Assist System)


    B295842
  1. Remove the 2 clips, screw and front fender mudguard LH.



3. REMOVE ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System)


    B353449
  1. Remove the screw.

  1. Detach the 2 clips to remove the rocker panel moulding cover LH.



4. REMOVE ROCKER PANEL MOULDING LH (w/ Intuitive Parking Assist System)
  1. Put protective tape around the rocker panel moulding LH.

  1. Remove the 4 screws.



  1. Detach the 15 clips to remove the rocker panel moulding LH.


    B353494E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



5. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH


    B353451E01
  1. Put protective tape around the front fender moulding sub-assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the grommet.

  1. w/ Intuitive Parking Assist System:

    1. Remove the clip.



    B354488
  1. Remove the 6 screws.

  1. Using a moulding remover, detach the 9 clips to remove the front fender moulding sub-assembly LH.

  1. Remove the 9 clips.



6. REMOVE REAR DOOR OUTSIDE MOULDING LH (w/o Intuitive Parking Assist System)


    B239369E01
  1. Put protective tape around the rear door outside moulding LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 clips and 2 claws to remove the rear door outside moulding LH.

  1. Remove the 7 clips.



7. REMOVE REAR DOOR OUTSIDE MOULDING LH (w/ Intuitive Parking Assist System)


    B353450E01
  1. Put protective tape around the rear door outside moulding LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 clips and 2 claws to remove the rear door outside moulding LH.

  1. Remove the 7 clips.



8. REMOVE NO. 3 OUTSIDE MOULDING RETAINER


    B239372
  1. Remove the screw.

  1. Detach the claw to remove the No. 3 outside moulding retainer.



9. REMOVE REAR QUARTER OUTSIDE MOULDING LH


    B239371E01
  1. Put protective tape around the rear quarter outside moulding LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 screws.

  1. Using a moulding remover, detach the 4 clips to remove the rear quarter outside moulding LH.

  1. Remove the 4 clips.