Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MOULDING

SIDE MOULDING > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. When installing the pad, heat the moulding surface using a heat light.

Standard:
Item
Temperature
Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the moulding excessively.



1. INSTALL FRONT FENDER OUTSIDE MOULDING PAD LH

HINT:
B239373
Only follow this procedure when replacing the front fender outside moulding pad LH.

  1. Install a new front fender outside moulding pad LH in the position shown in the illustration.



2. INSTALL REAR DOOR NO. 1 MOULDING PAD
  1. Clean the rear door outside moulding surface.

    1. Using a heat light, heat the rear door outside moulding surface.

    2. Remove the double-sided tape from the rear door outside moulding surface.

    3. Wipe off any tape adhesive residue with cleaner.



    B239375
  1. Install a new rear door No. 1 outside moulding pad.

    1. Remove the peeling paper from the face of a new rear door No. 1 outside moulding pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear door No. 1 outside moulding pad.



3. INSTALL REAR DOOR UPPER OUTSIDE MOULDING PAD
  1. Clean the rear door outside moulding surface.

    1. Using a heat light, heat the rear door outside moulding surface.

    2. Remove the double-sided tape from the rear door outside moulding surface.

    3. Wipe off any tape adhesive residue with cleaner.



    B239374
  1. Install a new rear door upper outside moulding pad.

    1. Remove the peeling paper from the face of a new rear door upper outside moulding pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear door upper outside moulding pad.



4. INSTALL NO. 1 QUARTER PANEL MOULDING PAD
  1. Clean the rear quarter outside moulding surface.

    1. Using a heat light, heat the rear quarter outside moulding surface.

    2. Remove the double-sided tape from the rear quarter outside moulding surface.

    3. Wipe off any tape adhesive residue with cleaner.



    B239376
  1. Install a new No. 1 quarter panel moulding pad.

    1. Remove the peeling paper from the face of a new No. 1 quarter panel moulding pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the No. 1 quarter panel moulding pad as shown in the illustration.