Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side)

REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
  1. Install the inner belt with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL REAR SEATBACK ASSEMBLY LH


B240263E01
  1. Fold down the seatback, set the seatback positioning wire on the hinge, and then temporarily install the bolt to the hinge.
    Text in Illustration 
    *1
    Positioning Wire

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Restore the seatback to the upright position and temporarily install the seatback with the 2 bolts.

  1. Tighten the bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



3. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY LH
  1. for Plastic Seatback Board:

    1. Attach the 2 claws and 4 clips to install the carpet.

    2. Attach the 3 claws and clip to install the carpet.

  1. for Seatback Board with Carpet:
    Attach the 4 claws and 5 clips to install the carpet.



4. INSTALL REAR SEATBACK COVER
  1. Attach the 4 claws to install the cover.

  1. Restore the seatback to the upright position and lock it.



5. INSTALL REAR SEAT HEADREST ASSEMBLY
  1. Install the rear seat headrest assembly .

  1. Return the seat cushion to its original position.