Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT INNER BELT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)

REAR CENTER SEAT INNER BELT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR CENTER SEAT INNER BELT ASSEMBLY
  1. Install the inner belt with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Attach the fastening tape, and install the band.



2. INSTALL REAR SEATBACK ASSEMBLY RH


B238041E01
  1. Fold down the seatback, set the seatback positioning wire on the hinge, and then temporarily install the bolt to the hinge.
    Text in Illustration 
    *1
    Positioning Wire

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Restore the seatback to the upright position and temporarily install the seatback with the 2 bolts.

  1. Tighten the bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Attach the 2 claws and connect the outer belt with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



3. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY RH
  1. for Plastic Seatback Board:

    1. Attach the 4 clips to install the carpet.

    2. Attach the 5 claws and 2 clips to install the carpet.

  1. for Seatback Board with carpet:
    Attach the 2 claws and 5 clips to install the carpet.



4. INSTALL REAR SEATBACK COVER
  1. Attach the 4 claws to install the cover.



5. INSTALL REAR SEAT HEADREST ASSEMBLY
  1. Install the headrest.