Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT INNER BELT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)

REAR CENTER SEAT INNER BELT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR SEAT HEADREST ASSEMBLY
  1. Remove the headrest.



2. REMOVE REAR SEATBACK COVER
  1. Press the seatback lock release button to release the lock and fold down the seatback.



    B237641
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY RH


  1. for Plastic Seatback Board:



      B238039
    1. Detach the 5 claws and 2 clips, and then remove the carpet.



    2. B238040
    3. Using a clip remover, detach the 4 clips and remove the carpet.



    B238017
  1. for Seatback Board with Carpet:

    1. Using a clip remover, detach the 5 clips.

    2. Detach the 2 claws and remove the carpet.



4. REMOVE REAR SEATBACK ASSEMBLY RH


B238088
  1. Remove the bolt and detach the 2 claws, and then disconnect the outer belt.

  1. Remove the 2 bolts that secure the seatback to the floor.

  1. Fold down the seatback, remove the bolt from the hinge, and then remove the seatback.

    NOTICE:
    Be careful not to damage the vehicle body.



5. REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY


B241736E02
  1. Detach the fastening tape and remove the band.

  1. Remove the bolt and inner belt.
    Text in Illustration 
    *1
    Band