Home › Drivetrain ยท AXLE AND DIFFERENTIAL › AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR

AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR
  1. Remove any old FIPG material.

    NOTICE:
    Be careful not to drop oil on the contact surfaces of the actuator and clutch case.

  1. Using gasoline or alcohol, wipe off any residual FIPG material on the contact surfaces.



    G023140E05
  1. Apply seal packing to the differential tube as shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent

    Text in Illustration 
    *1
    Seal Packing

    HINT:
    Install the actuator within 10 minutes of applying seal packing.

  1. Clean the threads of the 4 bolts and retainer bolt holes with toluene or trichloroethylene.

  1. Apply adhesive to 2 or 3 threads at the tip of the bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Install the actuator to the differential tube with the 4 bolts.

    Torque:
    21 N*m{ 210 kgf*cm , 15 ft.*lbf }

  1. Connect the actuator hose and connector.

  1. Support the differential with a jack.

  1. Install the 2 front mounting bolts and 2 nuts.

    Torque:
    137 N*m{ 1400 kgf*cm , 101 ft.*lbf }

  1. Install the No. 1 differential mounting nut.

    Torque:
    87 N*m{ 887 kgf*cm , 64 ft.*lbf }

  1. Install the differential breather tube bracket with the bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



2. ADD DIFFERENTIAL OIL
  1. Add differential oil .



3. CHECK FOR DIFFERENTIAL OIL LEAKAGE


4. INSTALL REAR ENGINE UNDER COVER ASSEMBLY
  1. Install the rear engine under cover assembly with the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



5. INSTALL NO. 1 ENGINE UNDER COVER


    A224743
  1. Hook the No. 1 engine under cover sub-assembly to the vehicle body as shown in the illustration.

  1. Install the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



6. INSTALL FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE