Home › Drivetrain ยท AXLE AND DIFFERENTIAL › AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR

AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



3. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the 4 bolts and rear engine under cover assembly.



4. DRAIN DIFFERENTIAL OIL


5. REMOVE AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR


    C097020E06
  1. Remove the bolt and disconnect the differential breather tube bracket.

  1. Support the differential with a jack.

  1. Remove No. 1 differential mounting nut.

  1. Remove the 2 mounting bolts and nut.
    Text in Illustration 
    *1
    Mounting Bolt
    *2
    Mounting Nut

  1. Disconnect the actuator hose and connector.

  1. Lower the jack.



    F043679E01
  1. Remove the 4 bolts and actuator.