Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

NOTICE:
In the table below, the valves listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Telematics / Data List.

  5. According to the display on the Techstream, read the "Data List".

    Telematics 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Emergency Switch
    Manual (SOS) switch / OFF or ON
    OFF: Manual (SOS) switch not pressed
    -
    ON: Manual (SOS) switch pressed
    -
    Current Com Back-Up Battery
    BUB (Back-Up Battery) installation history / with or without
    with: BUB (Back-Up Battery) connected at some point (does not guarantee that BUB (Back-Up Battery) currently connected)
    -
    without: DCM (Telematics Transceiver) has no record of BUB (Back-Up Battery) ever being connected
    -
    Number of Trouble Codes
    The number DTCs which is currently output
    -
    -