Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > DCM POWER SOURCE CIRCUIT

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the DCM (Telematics Transceiver).

WIRING DIAGRAM


E196655E17


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (DCM - BATTERY AND BODY GROUND)


    E192516E26
  1. Disconnect the F39 DCM (Telematics Transceiver) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F39-4 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F39-1 (+B) - F39-4 (E)
    Always
    11 to 14 V
    F39-7 (IG2) - F39-4 (E)
    Ignition switch ON
    11 to 14 V
    F39-8 (ACC) - F39-4 (E)
    Ignition switch ACC
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to DCM [Telematics Transceiver])



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)