Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > HEALTH CHECK

for Preparation Click here



HEALTH CHECK
Health Check provides an overall view of the vehicle status including telematics. Health Check will provide the DCM (Telematics Transceiver) software version, PRL version, and applicable DTCs and fault codes related to telematics.
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Click "Health Check".

    Fault Code
    Reason
    62
    VIN not recognized by telematics provider
    64
    DCM (Telematics Transceiver) not recognized
    65
    VIN mismatch with DCM (Telematics Transceiver)

    HINT:
    1. If Health Check results in a telematics issue, a specific Fault Code will be displayed.
    1. If a fault code occurs, follow the procedure below:
      1. Fault 62*: Press the manual (SOS) switch and inform the operator of the error message.
      2. Fault 64: Press the manual (SOS) switch and inform the operator of the error message.
      3. Fault 65*: Replace the DCM (Telematics Transceiver) with a new service part and perform DCM Activation.
        1. *: Verify that the VIN is correct in the vehicle ECU. Run Vehicle Inquiry on the Techstream and verify that the VIN is correct.



  4. Data is displayed under "Telematics".


    E192511E01