Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1452    Accumulator Low Pressure

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1452
After braking, the fluid pressure inside the accumulator is below the threshold within 3.2 seconds.
  1. Hydraulic circuit
  2. Master cylinder solenoid (Accumulator pressure sensor)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.CUSTOMER PROBLEM ANALYSIS
  1. Check with the customer to determine if frequent braking has been performed.


NEXT


2.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Wait for 99 seconds.

  1. Check if the same DTC is output (Click here).

    Result  
    Result
    Proceed to
    DTC is output
    A
    Frequent braking was not performed and DTC is not output
    B
    Frequent braking was performed and DTC is not output
    C

    HINT:
    Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.



B
USE SIMULATION METHOD TO CHECK (Click here)

C
END
A


3.CHECK HYDRAULIC CIRCUIT
  1. Check the hydraulic circuit (Click here).

    OK:
    Hydraulic circuit is normal (no leakage).



NG
REPAIR HYDRAULIC CIRCUIT
OK


4.READ VALUE USING TECHSTREAM (ACCUMULATOR SENSOR)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.


ABS/VSC/TRAC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Accumulator Sensor
Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V
3.58 to 5 V
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.
  1. Check that the accumulator output value is normal.

    OK:
    Accumulator pressure sensor value is normal.



NG
REPLACE MASTER CYLINDER SOLENOID
OK


5.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID