Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    51    Side Auto Step LH Stowing Timeout

DTC    52    Side Auto Step LH Deploying Timeout

DTC    53    Side Auto Step RH Stowing Timeout

DTC    54    Side Auto Step RH Deploying Timeout

DTC    55    Motor LH Spining Freely

DTC    56    Motor RH Spining Freely

for Preparation Click here


DESCRIPTION

When fully deploying or stowing the automatic running board takes more than 4 seconds, or when the side auto step motor hall sensor pulse signal exceeds the maximum pulse count, the side auto step ECU halts the operation of the automatic running board.

DTC No.
DTC Detection Condition
Trouble Area
51
Side auto step motor LH operates for 4 seconds or more.
  1. Power lift step assembly
  2. Side auto step motor assembly
52
53
Side auto step motor RH operates for 4 seconds or more.
54
55
The side auto step motor LH hall sensor pulse count is more than the maximum number of pulses per full travel.
56
The side auto step motor RH hall sensor pulse count is more than the maximum number of pulses per full travel.

INSPECTION PROCEDURE

1.CHECK AUTOMATIC RUNNING BOARD OPERATION
  1. Confirm the operation of the automatic running board and proceed to the steps indicated below.

    Result:

    Result
    Proceed to
    The side auto step motor turns over at high speed for 4 seconds and then stops. (The automatic running board does note move)
    A
    The side auto step motor turns over at high speed for 4 seconds and then stops. (The automatic running board is stowed or deployed)
    B
    The side auto step motor turns over at low speed for 4 seconds and then stops. (The automatic running board stops partway during stowing or deploying operation)
    C



B
REPLACE SIDE AUTO STEP MOTOR ASSEMBLY (Click here)

C
Go to step 3
A


2.INSPECT POWER LIFT STEP ASSEMBLY
  1. Check that the links of the power lift step assembly are properly installed.

  1. Check that the links of the power lift step assembly are not damaged.

OK:
Links of the power lift step assembly are properly installed.
Links of the power lift step assembly are not damaged.



NG
REPLACE POWER LIFT STEP ASSEMBLY (Click here)
OK

REPLACE SIDE AUTO STEP MOTOR ASSEMBLY (Click here)  

3.INSPECT POWER LIFT STEP ASSEMBLY
  1. Check that the links of the power lift step assembly are properly installed.

  1. Check that the links of the power lift step assembly are not damaged.

  1. Check that there is no dirt or foreign matter jamming the power lift step assembly links.

HINT:
  1. In cold times, snow or ice may jam the power lift step assembly links and prevent them from moving smoothly.
  2. Clean any dirt and foreign matter jamming the moving link sections of the power lift step assembly if necessary.

OK:
Links of the power lift step assembly are properly installed.
Links of the power lift step assembly are not damaged.
There is no dirt or foreign matter jamming the moving sections of the power lift step assembly links.



NG
REPLACE POWER LIFT STEP ASSEMBLY (Click here)
OK

REPLACE SIDE AUTO STEP MOTOR ASSEMBLY (Click here)