Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › AIR PUMP

AIR PUMP > INSTALLATION

for Preparation Click here



1. INSTALL AIR PUMP ASSEMBLY


    A223879E01
  1. Attach the 3 fittings of the air pump insulators to install the air pump assembly to the air pump bracket.
    Text in Illustration 
    *1
    Air Pump Insulator
    *2
    Air Pump Assembly
    *3
    Air Pump Bracket

  1. Attach the wire harness clamp and air pump connector clamp.

  1. Install the air pump assembly with bracket with the 3 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the air pump connector and attach the wire harness clamp.



2. INSTALL NO. 1 AIR INJECTION SYSTEM HOSE


  1. Connect the No. 1 air injection system hose so that its paint marks align with the projections of the air tube and air pump assembly as shown in the illustration.


    A289617E01

    HINT:
    1. Make sure the paint mark of the No. 1 air injection system hose is facing upward.
    2. Make sure the direction of the hose clamp is as shown in the illustration.


    Text in Illustration 
    *1
    Projection
    *2
    Paint Mark
    *a
    Upper
    *b
    RH Side
    *c
    Front
    -
    -



3. INSTALL AIR PUMP COVER


    A273789E01
  1. Install the air pump cover with the 3 claws.
    Text in Illustration 
    *1
    Inlet

    HINT:
    Make sure the inlet of the air pump cover is oriented correctly and completely attached when installing the air pump cover.