Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E278321E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    E283539E02
  1. Disconnect the G37 navigation receiver assembly connector.

  1. Disconnect the G39 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G37-13 (VV+) - G39-6 (VV+)
    Always
    Below 1 Ω
    G37-14 (VV-) - G39-11 (VV-)
    Always
    Below 1 Ω
    G37-13 (VV+) - Body ground
    Always
    10 kΩ or higher
    G37-14 (VV-) - Body ground
    Always
    10 kΩ or higher
    G37-12 (SG) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (Navigation Receiver Assembly)
    *b
    Front view of wire harness connector
    (No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)