AUDIO AND VISUAL SYSTEM > Display Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the G49 radio and display receiver assembly connector.
Disconnect the G39 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G49-13 (VV+) - G39-6 (VV+) | Always | Below 1 Ω |
| G49-14 (VV-) - G39-11 (VV-) | ||
| G49-13 (VV+) - Body ground | Always | 10 kΩ or higher |
| G49-14 (VV-) - Body ground | ||
| G49-12 (SG) - Body ground |
|
| ||||
| OK | ||
| ||