Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B1532    LVDS Signal Malfunction (from Extension Module)

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
B1532
When one of the conditions below is met:
  1. Stereo component tuner assembly is/was not connected while the ignition switch is/was ACC or ON.
  2. Communication between the navigation receiver assembly and the stereo component tuner assembly is/was not possible when the engine is/was started.
  1. Stereo component tuner assembly power source circuit
  2. LVDS circuit between navigation receiver assembly and stereo component tuner assembly
  3. Stereo component tuner assembly
  4. Navigation receiver assembly
  5. Harness or connector

WIRING DIAGRAM


E282848E03


INSPECTION PROCEDURE

NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
  1. Disconnect the s1 and t1 navigation receiver assembly connectors.

  1. Disconnect the s2 and t2 stereo component tuner assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    s1-1 (USV4) - s2-1 (USV4)
    Always
    Below 1 Ω
    s1-2 (US4-) - s2-2 (US4-)
    Always
    Below 1 Ω
    s1-3 (US4+) - s2-3 (US4+)
    Always
    Below 1 Ω
    s1-4 (UGD4) - s2-4 (UGD4)
    Always
    Below 1 Ω
    s1-5 (USG4) - s2-5 (USG4)
    Always
    Below 1 Ω
    t1-4 (+B2) - t2-4 (+B2)
    Always
    Below 1 Ω
    t1-3 (ACC2) - t2-3 (ACC2)
    Always
    Below 1 Ω
    t1-8 (GND2) - t2-8 (GND2)
    Always
    Below 1 Ω
    s1-1 (USV4) - Body ground
    Always
    10 kΩ or higher
    s1-2 (US4-) - Body ground
    Always
    10 kΩ or higher
    s1-3 (US4+) - Body ground
    Always
    10 kΩ or higher
    s1-4 (UGD4) - Body ground
    Always
    10 kΩ or higher
    s1-5 (USG4) - Body ground
    Always
    10 kΩ or higher
    t1-4 (+B2) - Body ground
    Always
    10 kΩ or higher
    t1-3 (ACC2) - Body ground
    Always
    10 kΩ or higher
    t1-8 (GND2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.REPLACE HARNESS AND CONNECTOR (LVDS COMMUNICATION LINE)
  1. Replace the harness and connector (LVDS communication line).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
Go to step 4
OK

END 

4.REPLACE STEREO COMPONENT TUNER ASSEMBLY
  1. Replace the stereo component tuner assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END