Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B158F    AV Signal Stoppage (Low Battery Voltage)

for Preparation Click here


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the navigation receiver assembly dropping temporarily.

DTC No.
DTC Detection Condition
Trouble Area
B158F
A video or audio signal is interrupted when the battery voltage drops.
  1. Navigation receiver assembly
  2. Harness or connector

WIRING DIAGRAM


E268488E01


INSPECTION PROCEDURE

NOTICE:
  1. After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.
  2. Inspect the fuses for circuits related to this system before performing the following procedure.

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)


    E268487
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Check the battery voltage.

    Standard Voltage:
    11 to 14 V

    HINT:
    This display is updated once per second.



NG
Go to step 3
OK


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK 

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE)
  1. Disconnect the G6 navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G6-4 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)